4
Step 2
Place the nut in the hexagon hole on the sensor, then
insert the screw in other side and tighten it by the screw
driver .
Step 3
Insert the other side of the pole to the square hole of the
plastic stand .
NOTE:
Ensure the pole and stand's indicator align .
Step 4
Place the nut in the hexagon hole of the stand, then
insert the screw in other side and then tighten it by the
screw driver .
Install the wireless 7-IN-1 sensor in an
open location with no obstructions above
and around the sensor for accurate rain
and wind measurement . Install the sensor
with the smaller end facing the North to
properly orient the wind direction vane .
Secure the mounting stand and clamps
(included) to a post or pole, and allow
minimum 1.5m off the ground.
1.5 meter off
the ground
Point to
NORTH
Add rubber
pads before
mount on the
pole
