1.
From the sink / countertop:
a.
Place the large rubber washer (#9) over the faucet hole.
b.
Place the LED Display Plate (#7) on top of the large rubber washer.
Feed the attached black cable down through the hole in the sink.
Rotate the LED Display Plate so that the indicator light will be easy
to see.
c.
Place the small rubber washer (#6) on top of the LED Display Plate.
d.
Place the faucet base (#3) over the small rubber washer and
LED Display Plate. Feed the faucet stud (#4) and blue tubing (#5)
down through the hole in the sink. The faucet stud should now be
accessible below the sink.
2.
From under the sink:
a.
Slide the black track washer (#10) (with the flat side down) upward
over the threaded faucet stud. Guide the black wire (#8) through
the track to protect the wire and prevent it from becoming pinched
between the sink and the stud nut.
b.
Slide the hard plastic washer (#11) upward over the blue tubing
(#5), black track washer (#10), black wire (#8), and faucet stud
(#4).
c.
Slide the lock washer (#12) upward over the faucet stud, below
the hard plastic washer.
d.
Screw on the stud wing nut (#13) below the lock washer.
e.
Hand-tighten the wing nut to secure the faucet.
3.
Prepare the Filter Monitor Unit (FMU)
a.
Guide the black wire (#8) from under the sink to the Filter Monitor
Unit (#14), and plug it into the top of the FMU.
b.
Open the FMU and pull out the battery holder. Insert two (2) AA
batteries (not included) into the battery holder, making sure to
match the + and – signs. Reinsert the battery holder.
c.
Press and hold the check/reset button on the FMU for six (6)
seconds. You should hear a long audio sound, and the LED Display
Plate will flash red and then green several times.
d.
Snap the cover back onto the FMU.
e.
Peel off the paper backing from the hook-and-loop connector
strip, and attach one piece to the back of the FMU.
9
Summary of Contents for CB-As
Page 23: ...Notes...