1.
Using a paper towel or cloth, dry off all connections and the system housing.
2.
Make sure that all connections are tightly secured.
3.
Remove any air and loose carbon from the system.
a. On a below-sink configuration:
i.
Turn the water supply back on; rotate both the Adapta Valve
shutoff valve and either the water supply Angle Stop Valve or
water shutoff valve counter-clockwise to engage the flow of
water through the pipes.
ii.
Turn the handle on the CB-As faucet to start the flow of filtered
water.
iii.
Allow water to flow through the DWS and the faucet for 30
minutes. This purges any air and loose carbon from the system.
iv.
Adjust the Angle Stop Valve or water shutoff valve so that the
water flow to the drinking water faucet does not exceed the
flow rate.
NOTE: It takes approximately 15 seconds to fill a quart at 1.0
gallons per minute flow rate.
b. On a countertop configuration:
i.
Press the right button on the diverter valve to select the filtered
water spout. The water will flow through the DWS and emerge
from the smaller opening on the diverter valve.
ii.
Allow water to flow through the DWS and filtered water spout
for 30 minutes. This purges any air and loose carbon from the
system.
iii.
Press the left button to select the unfiltered water spout, and
then turn off the faucet.
4.
Check all connections to make sure that there are no leaks.
5. Congratulations! Your system is now ready for use!
Prepare Your Drinking
Water System for Use
20
Summary of Contents for CB-As
Page 23: ...Notes...