CB Tech CB-As, Installation Manual

Page: 15 / 24

Connect the Tubing to the Housing
2. Fully insert the tubing into the adapter on the INLET port of the system
housing; the tubing should be inserted 5/8” into the adapter.
NOTE: When pushing the tubing into the adapter, you will encounter some
resistance. This does not mean that the tube is fully inserted. Continue to
push firmly until the tubing is inserted as far as possible (roughly 5/8” into the
adapter).
3. Pull on the tubing to make sure that it is securely connected.
Mount the System Under the Sink (Below Sink Kit ONLY)
1. Attach the metal bands to the mounting bracket:
a.
Using a slotted (flat-blade) screwdriver, loosen the connector
screw on each of the two metal bands so that the slotted side of
the bands separate from the connector screw.
b. Insert the slotted end of one metal band into one slot of the
mounting bracket.
i. Thread it across the curved back of the mounting bracket and
through the slot on the other side of the curved back.
ii. Thread the slotted end of the metal band back into the
connector screw and slightly tighten the screw to reconnect
the band into a circle.
c.
Repeat step 1-b for the other metal band, using the second set of
slots framing the curved back of the mounting bracket.
15