Below Sink Kit Components
1.
Connect the included Inlet adapter (MC738) to the system housing’s
labeled Inlet port. Rotate the adapter clockwise, first by hand, then
using a wrench, to tighten onto the system.
2.
Connect the included Outlet adapter (MC741) to the system housing’s
labeled Outlet port. Rotate the adapter clockwise, first by hand, then
using a wrench, to tighten onto the system.
Connect Tubing to the Outlet Port
1.
Using wire cutters or a knife, cut
(square cut) the tip end off of the
blue plastic tubing (either connected
to the faucet or a separate piece
included with the Capacity Monitor).
Do not use scissors.
2.
Fully insert the tubing into the adapter
on the OUTLET port of the system
housing; the tubing should be inserted 5/8” into the adapter.
NOTE: When pushing the tubing into the adapter, you will encounter
some resistance. This does not mean that the tube is fully inserted.
Continue to push firmly until the tubing is inserted as far as possible
(roughly 5/8” into the adapter).
3.
Pull on the tubing to make sure that it is securely connected.
Connect Tubing to the Inlet Port
1.
Using wire cutters or a knife, cut
(square cut) the tip end off of the
clear plastic tubing connected to the
Adapta Valve. Do not use scissors. Do
not cut more than 1/2” off of the end
of the clear plastic tubing.
Connect the Tubing to the Housing
14
blue tubing
insert
OUTLET
adapter
INLET
adapter
clear tubing
insert
Summary of Contents for CB-As
Page 23: ...Notes...
