CASUALPLAY Q-Retraktor Fix, Instruction Manual

Page: 24 / 98

22
• Position the child seat on the vehicle seat facing forwards.
• Extract the isofix connectors using the front button. Pull the button and
turn it to the right (fig.7).
• Press the safety seat against the vehicle seat (fig.8) until both isofix
connectors are fastened into the seat anchor points. It will click when
correctly fastened (fig.9), and a green signal will appear on each
connector (fig10).
• Adjust the inclination of the seat. To do this consult the section referring
to adjusting the reclining position.
• Using the central button, adjust the chassis of the safety seat until it
touches the backrest of the vehicle seat. Pull the button and turn it to the
left (fig.11).
• Take the two stoppers off the front part of the base (fig.20).
• Simultaneously press the two pivots found on the upper tubes (fig.21).
• Insert both tubes into the front slots. They will click when correctly
fastened (fig.22).
• To adjust the height of the support leg, pull the red button found on the bar
and pull the support foot until it touches the floor. Release the red part and
check that it has not got stuck between two locking positions (fig.23).
WARNING: In order to obtain the maximum support possible, place it in
the correct locking position.
WARNING: The support foot should not be in mid-air or resting on an
object (fig.24).
• Unfasten the harness buckle.
• Seat the child in the child car seat.
• Adjust the headrest.
• Extract the harness straps by pulling the top part while at the same time
pulling the clasps and passing the straps over the child’s shoulders.
• Fasten the safety buckle by joining the two clasps and inserting them
into the buckle.
• The Retraktor fix harness is fitted with an automatic wind up system that
adjusts the straps to fit the child’s body.
• Lastly, make sure that the harness fits the child’s body correctly, and if
necessary, pull the abdominal belt a bit to eliminate any loose gaps.