Carrier i-Vu XT, Installation And Startup Manual

Page: 25 / 50

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 22 All rights reserved
Gig-E Port using BACnet/IPv4
Primary BACnet/IP
Home network
or
Set as home
This is typically the network that is communicating with the building automation
system's application. This sets the BACnet Address of the Device Object. If the
port is
Enabled , the user can set this port as the home network to identify it as
the connection to the i-Vu® application.
Click Disable if you want to disable the port from use.
Auto Generate Network
Number If checked, network number is autogenerated, which then automatically sets to
((IP network rotary switch address) x 10) + 0.
Uncheck to use Custom Static Address Mode .
Network Number Specify a number for the BACnet/IP network or set to 0 if the port is not used.
The network number is 0 by default. Filled in automatically if Autogenerate
Network Number is checked.
NOTE When downloaded from the i-Vu® application, these numbers match those
set using SiteBuilder.
Address Mode Select the type of addressing the router is to use. See Addressing the i-Vu® XT
Router.
Select Default IP Address to automatically assign the following to the router:
•
IP address = 192.168.168. x
where x is the setting on the rotary switches in the range from 1 to 253
•
Subnet Mask = 255.255.255.0
•
Default Gateway = 192.168.168.254
Select Custom Static if you have a permanent IP address which does not change
and is usually obtained from the network administrator.
Address Displays the unique address of the device, if assigned. Editable only if using
Custom Static addressing.
Subnet Mask Displays the Subnet Mask of the device, if assigned. Editable only if using Custom
Static addressing.
Default Gateway Displays the Default Gateway of the device, if assigned. Editable only if using
Custom Static addressing.
UDP Port The port that the i-Vu® XT Router will use for BACnet communication.
If the i-Vu® XT Router has two BACnet/IP networks communicating on the Gig-E
port, confirm that the home network interface has the port number set to what
the i-Vu® application will use for BACnet communication.