4
Fig. 7 - Harness Detail
W7220
Controller
Control
Box
Coil
Filter
Economizer
14. While everything is open install and wire any other accessories
and/or sensors as applicable and convenient, per their installation
instructions and/or the Configuration section of this instruction.
Some accessories require that unit ducting already be installed.
NOTE: If also installing a power exhaust accessory, skip step 16 and
follow the power exhaust instructions instead.
16. Install the EconoMi$er X hood over the EconoMi$er X. Use screws
provided. (See Fig. 10.)
17. The W7220 EconoMi$er X controller is shipped mounted to a
bracket. Install the controller / bracket in the top left corner of the
unit control box as shown in wiring diagram, Fig. 8. Screw in place
through pre-punched holes.
18. Connect the plugs coming from the controller as shown in wiring
diagram, Fig. 7 and 8.
19. Adjust controller settings (minimum position, outside air, etc.) per
instructions detailed later in this instruction.
20. Follow all local and other applicable codes.
Fig. 8 - Typical EconoMi$er X Wiring Diagram
