Adding the Carrier® ChillerVu™ into the i-Vu® or Field Assistant system
Carrier® ChillerVu™
(OPN-PSM-MPCXPE)
Carrier Proprietary and Confidential
CARRIER CORPORATION ©2017
Installation and Start-up Guide
36
All rights reserved
To add control programs and graphics in the i-Vu® interface
Use the following procedure to add all of the control programs (.equipment files) that you need to run your system.
1
Select the Carrier® ChillerVu™ in the navigation tree.
2
On the
Devices
>
Manage
tab, select the Carrier® ChillerVu™ in the list on the page.
3
Click the
Add Control Program
button
. A dialog window appears.
4
Type a
Display Name
for the control program.
5
Select the
Controller
that you are adding the program to.
NOTE
If you already have the maximum number of control programs for a controller, it will not appear in the
list.
6
To add the control program, do the following:
If the control program is...
In the
Control Program
drop-down
list
1.
Select the control program that you generated in
EquipmentBuilder or Snap.
2.
Click
Accept
.
Not in the
Control Program
drop-
down list
1.
Click
Add New
.
2.
Browse to select the control program.
3.
Click
Open
.
4.
Click
Continue
.
5.
Click
Close
.
6.
Click
Accept
.
1
To add a graphic, click
Add New
under
Views
and browse to your .view file.
2
Click
Continue
. When message appears
File added successfully
, click
Close
.
3
Click
Close
again.
4
Right-click on the controller in the controller list and select
Check Status
from the list. The status of the
controller should say
File Mismatch
.
5
Click the
Download
All Content
button.
6
Configure the controller on the
Properties
page >
Control Program
tab.
7
Check out and commission the equipment.