Wiring for third party protocols
Carrier® ChillerVu™
(OPN-PSM-MPCXPE)
Carrier Proprietary and Confidential
CARRIER CORPORATION ©2017
Installation and Start-up Guide
29
All rights reserved
To connect to the LonWorks network using the LonWorks Option Card
1
Turn
off
the Carrier® ChillerVu™'s power.
2
Set DIP switch 5 to
TPI
.
3
Plug the 's ribbon cable into the Option Comm port on the Carrier® ChillerVu™.
CAUTIONS
○
You
MUST
ground the Carrier® ChillerVu™ to earth ground, using the Rnet Gnd connector.
○
The controller must be
OFF
before being connected.
4
Connect LON network to pins
1
and
2
on the Option Card.
5
Turn
on
the Carrier® ChillerVu™'s power.
To connect to the LonWorks network using the SLTA-10
1
Turn
off
the Carrier® ChillerVu™'s power.
2
Set DIP switch 5 to
TPI
.
3
Set the jumper to EIA-232.
