Carrier 40RC003603, Owner'S Manual

Page: 8 / 19

8
Cancel of Zone Entering
FILTER RESET
1
SET
ZONE
ON
UNIT
2
LOUVER FAN
TEMP. MODE MONITOR/SET ALL/ZONE ZONE UNIT ON CENTER/LOCKED CHECK
ZONE SET/ENTER SELECT OFF TIMER ON
1 2 4 5 3
FILTER RESET
1
SET
ZONE
ON
UNIT
2 3 4 5
LOUVER FAN
TEMP. MODE MONITOR/SET ALL/ZONE ZONE UNIT ON CENTER/LOCKED CHECK
ZONE SET/ENTER SELECT OFF TIMER ON
1
2
3
2
[ZONE SET]
[ZONE SET]
1
SET
ZONE
UNIT
(NOTE) Setting returns to one at shipment, and one unit as one zone is set in each 64 zones.
END
Push “MONITOR/SET” button again. The Zone set up completes and indication returns to “MONITOR”.
Indication returns automatically to “MONITOR” after 15 seconds even if this step is not executed.
Cancel of zone entering for each unit
1
Push “ZONE SET/ENTER” button while “MONI-
TOR” is indicated.
Indication changes to [ZONE SET].
2
Pushing “ZONE” button matches Zone No. to be
canceled.
“SET”, “ZONE”, “UNIT” indications and the Unit
No. entered in the corresponding zone go on.
“1” is indicated at shipment from the factory.
Unit No.1 is set to Zone No.1.
3
Pushing “UNIT” button matches Unit No. to be
canceled.
The matched No. is indicated in Unit No. indica-
tion part and Operation monitor indication part.
4
When keeping “SELECT” button pushed for approx. 3 seconds, the lighting Unit No. in the operation monitor
indication part flashes.
Repeat steps
3
and
4
, and select the other Unit No. to be canceled.
5
When “ZONE SET/ENTER” button is pushed, “ ” indication under Unit No. in the Operation monitor indication
part goes off.
END
Push “MONITOR/SET” button again. The Zone set up completes and indication returns to “MONITOR”.
(Indication returns automatically to “MONITOR” after 15 seconds even if this step is not executed.)
Collective cancel
1
Push “ZONE SET/ENTER” button while “MONI-
TOR” is indicated.
Indication changes to [ZONE SET], and Unit No.
entered in Zone No.1 is indicated in the Opera-
tion monitor indication part.
2
Pushing “ALL/ZONE” and “CHECK” buttons
simultaneously for approx. 5 seconds
Indication in the Operation monitor indication
part changes.