7
Entering to Zone
Multiple systems of the indoor units are set as a zone. Start/Stop control and every kind setting are available in each
zone. At shipment from the factory, one unit as one zone is set in 64 zones each.
(NOTE 1) If a unit is set to an incorrect zone, set the unit to the correct zone another time.
(The zone which has been finally set/entered is valid.)
(NOTE 2) A unit cannot be set to multiple zones.
(NOTE 3) While zone entering is set up, the unit which has been already entered is indicated with unit No. and “ ” in the
operation monitor indication part when zone No. is indicated.
Set up and entering
[Set up example]
Set Unit No. “1”, “2”, “3”, “4”, “5” to Zone No.1.
1
Push “ZONE SET/ENTER” button while “MONI-
TOR” is indicated.
Indication changes to [ZONE SET].
2
Pushing “ZONE” button indicates Zone No.”1”.
“SET”, “ZONE”, “UNIT” indications and the Unit
No. entered in the corresponding zone go on.
“1” is indicated at shipment from the factory.
Unit No.1 is set to Zone No.1.
3
Pushing “UNIT” button indicates Zone No.”2”.
“02” in Unit No. indication part and No.“2” in
Operation monitor indication part flash.
4
When pushing “SELECT” button, the flashing
Unit No. in the operation monitor indication part
goes on.
Repeat steps
3
and
4
, and select Unit No. 3,
4, and 5.
5
When “ZONE SET/ENTER” button is pushed,
the contents are entered.
(Unit No. and “ ” in the Operation monitor
indication part change to lighting .)
1
SET
ZONE
UNIT
2 3 4 5
01
02
03
04
05 to 62
63
64
64
63
62
61
60 to 03
02
01
FILTER RESET
1
SET
ZONE
ON
UNIT
2
LOUVER
FAN
TEMP.
MODE
MONITOR/SET ALL/ZONE
ZONE
UNIT
ON CENTER/LOCKED
CHECK
ZONE SET/ENTER SELECT
OFF
TIMER ON
FILTER RESET
49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64
33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
1
MONITOR
ON
ON
UNIT
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
TEMP.
˚C
LOUVER
FAN
TEMP.
MODE
MONITOR/SET ALL/ZONE
ZONE
UNIT
ON CENTER/LOCKED
CHECK
ZONE SET/ENTER SELECT
OFF
TIMER ON
1
5 4
2 3
MODE
COOL
FAN
HIGH
END
Push “MONITOR/SET” button again. The Zone
set up completes and indication returns to
“MONITOR”.
Indication returns automatically to “MONITOR”
after 15 seconds even if this step is not ex-
ecuted.
When setting another zone continuously,
repeat steps
2
,
3
,
4
, and
5
.
Every pushing “
” buttons of ZONE and UNIT, indication No.
moves up by 1, and moves up successively by keeping
pushed. Every pushing “
” buttons of ZONE and UNIT,
indication No. moves down by 1, and moves down succes-
sively by keeping pushed.
[ZONE SET]
