the Access Bank II - SNMP from the network until the problem is resolved. User repairs must not be made. Do-
ing so will void your warranty.
Do not install the Access Bank II - SNMP on public coin service provided by the telephone company. Connec-
tion to Party Line service is subject to state tariffs. (Contact your state public utilities commission for further
information.)
To minimize damage caused by local lightning strikes and other electrical surges, it is recommended that the
customer install an AC surge arrestor in the AC outlet to which the Access Bank II - SNMP is connected.
S
AFETY
R
EQUIREMENTS
DANGER!
Always exercise caution when installing telephone lines.
Never touch uninsulated telephone wires and terminals unless the telephone line has been disconnected at the
Network Interface (NI) as voltage potentials as high as 300 Vac may be present across the transmit and receive
pairs.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Refer to the installation chapter in this manual for a safe and proper installation procedure. All wiring external
to this equipment should follow the current provision of the National Electrical Code.
N
ATIONAL
E
LECTRICAL
C
ODE
R
EQUIREMENTS
The Access Bank II - SNMP is CCL certified and is in compliance with ANSI/UL Std. 1459. The CCL certifi-
cation number for the product safety listing of the Access Bank II - SNMP is C86-0303.
I
NDUSTRY
C
ANADA
R
EQUIREMENTS
Load Number: 5
CP-01, Part 1
Section 10.1
“NOTICE: The Canadian Department of Communications label identifies certified equipment. This certifica-
tion means that the equipment meets certain telecommunications network protective, operational and safety re-
quirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the
local telecommunications company. The equipment must also be installed using an acceptable method of con-
nection. In some cases, the company’s inside wiring associated with a single line individual service may be ex-
tended by means of a certified connector assembly (telephone extension cord). The customer should be aware
that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by
the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect the equipment.
Summary of Contents for Access Bank II SNMP
