Command Line Interface (CLI)
9/24/01
14-23
14.4.4.13 event
Use the
event
command to display or clear the event log.
14.4.4.14 exit
Use the
exit
command to end the current management session.
14.4.4.15 ip
Use the
ip
command to set and display the ip addresses for an SNMP management session This com-
mand is used to configure the system for SNMP and Telnet access.
Operations
Type
Comments
To
display the next 18
events
event
To display the entire
event log
event all
To display the first 18
events
event first
To clear the event log
event clear
Operations
Type
Comments
To end current session
exit
Ends current session
Operations
Type
Comments
To configure the Access
Bank SNMP parameters
ip addr 192.168.0.220
Configures the IP address
To verify configuration
using the show command
ip
Displays all current IP related
parameters.
To show Help
ip ?
Summary of Contents for Access Bank II SNMP
