9
MIXER OR TAP
INsTAllATION
STEP 1 – PrEParaTion for MounTinG ThE MiXEr or TaP
1
2
Shut off the water supply.
Remove the hexagonal nut, the disc
and the gasket. do not remove the
o-ring from the base of the mixer or
tap.
nUt
dISc
GaSKEt
o-RInG
STEP 2 – inSTallinG ThE MiXEr or TaP
1
2
Insert the inlet connection end of
each flexible tail through the hole in
the deck then place tap over deck
hole. Make sure the o-ring is located
between the deck and the bottom of
the mixer or tap.
Slide the gasket and disc onto the
threaded stud then screw on the
hexagonal nut and tighten.
o-RInG
nUt
dISc
GaSKEt
nUt
dISc
GaSKEt
o-RInG
o-RInG
