STEP 5
Fitting the bottle holder
•
Fit the bottle holder (115) to the handlebars (102) using
screws (116) and washers (101). Fit the screws turning with
fingers first to get the screws started. Thread the screws in a
few turns before using the 4mm Allen key.
•
Use the 4mm Allen key to tighten the screws.
STEP 6
Fitting the tablet
•
The tablet has 2 location holes in the base, these sit on 2 pins
in the charging dock (117). Hold the tablet at a slight angle as
shown in the picture and place the tablet on the 2 pins first,
then lay it back against the back plate. The tablet is fitted
with magnets in the base and back that attract it to the back
plate. When the tablet is located on the pins correctly it
won’t slide to the left or right.
•
Fit the tablet security bracket (128) with the screws (129) and
washers (130) using the 4mm Allen key. Hold the security
bracket down with slight pressure and tighten the screws to
secure the tablet.
•
Check the charging cable (107A) is plugged into the charging
dock (122).
STEP 7
Saddle adjustment
Your saddle comes ready fitted, but a 13mm spanner is included
if you wish to change the position. Release the M8 nuts on each
side of the saddle until sufficiently loose to move the saddle
to the desired position. Tighten the nuts again, checking the
saddle alignment as the nuts are evenly tightened.
CAROL | 13
Summary of Contents for BIKE 2.0
Page 1: ...CAROL BIKE 2 0 SETUP AND USER GUIDE...
Page 4: ...4 CAROL...
Page 10: ...10 CAROL...
Page 27: ...CAROL 27...
