18
5-2 Notes
▶
This analyzer is operated with AC110V only or AC220V only. Please verify the power source
before use. (Note that you can not change power source which is fixed upon supplying this
analyzer.)
▶
T
he following factors should be considered to properly locate the analyzer body :
━
To be setup in a place of no direct light rays, humidity, vibration and abrupt temperature
change.
━
To be setup in a indoor place where no emitted gas inflows.
━
To be setup in a height higher than 25cm from the ground.
▶
The analyzer should not be moved during the operation. It may cause an
incorrectness in the measured value.
▶
The probe should be located in a place where not affected by the wind.
▶
The probe may be so hot during the operation so that it should be carefully handled not to be
burned in insertion or removal.
▶
It needs to be noted that you should not stay in the gas emitting place during the operation.
▶
The analyzer should be used in a well-ventilated place only because the emitting gas contains the
CO and it can cause a fatal damage to a human body.
▶
This analyzer is Type-approved in accordance with the related government laws so that it is
extremely prohibited to disassemble, change, or rebuild the analyzer and also if you disassemble
the NDIR Module, you may not be guaranteed for the repair.
▶
NDIR module is the core part of the analyzer. Disassembly or assembly work is possible
only by the manufacturer's technician. In any circumstance, you or anyone else should not
attempt to disassemble it. If disassembled or re-assembled, proper A/S is not going to be
possible.
