16
Chapter 5. Installation Methods and Notes
5-1 Installation
5-1-1 Fit end of the probe hose into the measuring probe and the other end of the hose into the gas
inlet in the rear of the analyzer. If the fitting condition is not good and the air comes into flow
from outside, it may yield an incorrect measured value.
Therefore, please carefully verify the fitting condition before use.
5-1-2 Turn off the power switch and then connect the power cable to the power socket located in the
rear of the analyzer
※
Warning
This analyzer supports AC110V only or AC220V only.
(Please confirm the power source to use.)
