Carlton SP8018, Owner'S Manual, Page: 44 / 96

SP8018 SERVICING CUTTER WHEEL
•
PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
•
A standard cutter wheel on model SP8018
has a set of 48 total teeth. (2 straight, 23 left
angled and 23 right angled)
•
A locking pin is provided to hold cutter
wheel in position during tooth removal and
re-installation.
•
Locking pin will only lock on outer teeth.
NEVER PLACE HAND ON CUTTER
WHEEL TO HOLD IN PLACE WHILE
CHANGING TEETH. BE SURE TO
REMOVE PIN BEFORE OPERATING.
•
A Tooth Setting Gauge (P/N - 0450111) is
provided with each machine for proper tooth
installation. Line all teeth up with the inside
edge of the groove in the gauge. Set
ALL
teeth to this edge with gauge against pocket,
not against cutter wheel. All teeth are set 1
1/4” out of the pocket to the edge of the
carbide.
DANGER
More accidents occur while performing maintenance than any other time! Use extra caution!!
DO NOT PERFORM MAINTENANCE OF ANY KIND ON THIS MACHINE UNLESS:

The engine is turned off.

The ignition key has been removed.

The positive battery cable has been disconnected.

The cutter wheel is disengaged.

All machine parts have come to a complete stop.

All machine parts have had sufficient time to cool down.

No operator is in position at the controls to accidentally start machine.

At least 2 people are at the site where maintenance is performed.
CAUTION
Do not operate machine without a full set
of teeth. Operating machine without a
full set of teeth can cause excessive
vibration and premature bearing failure.
!
31