ENGLISH
4.2.1.1 Setpoint 1 Value Read-out (SP1)
Press and release.
After displaying the setpoint value for 2 seconds the instrument will re-
turn to display the input variable. Setpoint values are only shown if a
relay output module (1 or 2 relays) is installed.
4.2.1.2 Setpoint 2 Value Read-out (SP2)
Press and release.
4.2.1.3 Peak and Valley Values Read-out
Press and simultaneously and release.
4.2.1.4 Reset of Peak and Valley Values
Press , and simultaneously and release.
The peak and valley values are reset during power-up as well.
4.2.1.5 Programming Mode Access
Press and hold ; then press . Release both immediately after
the display shows .
4.2.1.6 Calibration Mode Access
Press and during power-up. Release both immediately after
the display shows .
4.2.1.7 ‘Hold’ Function
The ‘Hold’ function is standard for all versions and is located on the ter-
minals of the power supply module. By short-circuiting the ‘Hold’ input,
the indication on the display is frozen. When the ‘Hold’ function is ac-
tive, all other functions operate in normal way.
4.2.1.8 Setpoints
The setpoints can operate in four different ways depending on the pro-
gramming. See the following drawing.
18
▼
▲
▼
▲
▼
▲
▼
S
S
▲
S
Summary of Contents for EDM 35 -
Page 19: ...ENGLISH 19 Scaling Operation Setpoint Operation ...
Page 47: ...ENGLISH 47 Notes ...
Page 48: ...ENGLISH Notes ...
