Compa II series
Adjustments, settings and alignments
11.15 Service
instructions
33
6.6 Adjusting the position of printhead
Complete the following printhead settings to achieve the best possible
print image:
Align the heating line with the highest point of the print roller.
Density of the print image is the greatest at this point.
Set the parallelism of horizontal lines with the edge of the label.
CAUTION!
The printhead assembly can be damaged.
Attempting to adjust the printhead when the fixing screw (3)
is tight can lead to defects at the printhead assembly.
Always loosen the fixing screws (3) before adjusting
the printhead.
Figure 21
NOTICE!
Open and close the printhead locking device after each step of
the adjustment.
1. Check the alignment of printhead in the adjustment windows (1).
Compa II 162 + 162 T:
Check the alignment of printhead at the
slides (5).
2. If the printhead is not aligned properly, loosen the screw (3) about
one quarter turn.
3. If the printhead is not aligned properly, use the screws (2) to align
the lines on the printhead with the tips of the grooves and/or with
Compa II 162 + 162 T
to align the lines on the printhead mounting
bracket with the front edge of the slides (5).
Screw (2a) effects the inner half of the printhead, and screw (2b)
the outer half.
Turning clockwise moves the printhead forward.
Compa II 162 + 162 T:
Turning clockwise moves the printhead
backward.
Summary of Contents for COMPA II
