Adjustments, settings and alignments
Compa II series
30 Service
instructions
11.15
6.4 Setting the winding torque
The winding torque of a winder can be changed at the knurled ring of
the respective slipping clutch. The numbers on the knurled ring stand
for the value of the winding torque:
1: Smallest winding torque
7: Greatest winding torque
The current setting value is indicated by the number located at the
positions of the two locking tabs.
Figure 19
1. Unplug the printer from the electrical outlet and remove the rear
cover.
2. Press the knurled ring (1) of the slipping clutch toward the housing
wall.
The lock (2) of the knurled ring is released.
3. Turn the knurled ring to the desired position while pushing it.
4. Release the knurled ring in the desired position.
5. Ensure that the tabs of the lock are located completely in the
grooves of the setting value.
6. Measure the winding torque again and compare it to the setpoint.
Transfer ribbon winders (see chapter 6.2, on page 28)
Internal rewinder (see chapter 6.3, on page 29).
7. Repeat the adjustment until the measured winding torque is within
the tolerance range.
8. Pull the label photocell toward the cover side as far as possible
(see chapter 5.6, on page 21) and install the rear cover of the
printer.
Summary of Contents for COMPA II
