M
IRAGE
2-S
TAGE
Service
Manual
Carefree of Colorado
8
052588-301r4
8.
For HS configuration:
Remove the crown from the old motor. This will be used with the new motor.
The crowns are configuration specific.
9. Assemble the new motor:
Note:
The new and old motor components are not interchangeable.
9.1. Slide the crown onto the motor.
NOTE:
For VS configurations, use the new crown that is included with the motor. For HS configurations,
discard the included crown and use the existing crown that was removed previously.
9.2. Place the drive key into the slot of the motor shaft and slide the new drive onto the motor shaft
and over the drive key.
9.3. Secure the drive using the supplied retaining ring.
10. Partially insert the new motor with the crown and drive into the roller tube. Ensure that the motor drive
gear and crown are properly seated inside the roller tube.
NOTICE
For the HS configuration:
When the crown is seated in the roller tube, the canopy edge
with the polyrod must be in the fabric groove of the crown.
11. Attach the end plate to the motor the using the new screws and nuts provided. Make sure to match the
orientation from the old motor.
12. Route the new motor cable through the end plate.
13. Press the motor and end plate into the roller tube and attach the end plate to the housing using the
screws removed previously.
14. Route the new motor wire into the vehicle and attach at the junction box or control box (refer to wiring
diagrams on page 19 for the appropriate control system).
All wiring must conform to NEC (National
Electrical Code) and local codes
.
15. Use the manual override to roll the canopy onto the roller tube. The fabric must roll under the roller tube.
16. Install the end cap.
17. To test, restore power then extend and retract the awning.
18. It will be necessary to adjust the motor limits. Refer to page 2.
Summary of Contents for Mirage 2-Stage
Page 4: ......
