Carefree of Colorado Service
Manual
M
IRAGE
2-S
TAGE
052588-301r4
17
D06 O
NE
A
WNING
D
OES
N
OT
O
PERATE
NOTE: The awnings are programmed sequentially (i.e. #1, #2, #3, #4). If power is missing from an awning, the
subsequent awnings will not function (i.e. #1 and #2 works, #3 and #4 don't) and the touch-pad LEDs do not
illuminate. Check the power to the first non functioning control board in sequence (i.e. #3) and correct as
necessary before proceeding.
A
1. Shut off power source if not already done.
2. Open control boxes and disconnect the non-working
awning motor wires and a working awning's motor wires.
3. Connect the non-operating awning to the functioning
control board (i.e. awning #2 to control board #1).
4. Restore
power
5. Test the operation of the awning using the controls for
the functioning awning (in the example above #1
awning).
YES
Awning functions, control board of non-
working awning is defective – replace
control box.
NO
Return wires to original configuration.
Go to step B
B
Confirm awning motor is functioning
1.
1.7 With power off, connect awning motor directly to
110VAC power source.
White = Hot
Green = Ground
Red & Black are Motor Direction Control – connect
one
1.8 Briefly apply power.
1.9 Does awning move when power is applied?
YES
Awning motor is good, control box is
defective - replace
NO
Go to step B-2
2.
Test continuity and connections of motor wire between
control box and awning motor.
YES
Continuity is good, motor is defective –
replace
NO
Repair as required and retest
D07 A
WNING
(
S
)
DO NOT
R
ETRACT
D
URING WINDY CONDITIONS
The Direct Response auto-retract system operates by gauging the motion of the awning's leading edge, not by the
direct wind speed. Refer to the description in the operations section of the manual.
NOTE: The awnings have independent sensors and may not retract concurrently.
A
Press the power on button then press the auto-retract button.
Do the auto-retract LED flash?
YES The flashing LED indicate that the
sensor(s) have been disengaged or
other wise disabled. Go to step C
NO
Go to test B
B
Confirm standard awning operation. From the touch-pad,
operate the awnings.
YES
Operation is normal, Go to step C
NO
Refer to the appropriate test D02 or
D03
C
Check function of shaker sensor
1. Open the affected awning (does not have to be open all
the way).
2. Open the second awning.
3. Open control box and disconnect sensor from controller
board of awning that does not auto-retract.
4. If cable has been spliced between sensor and control
box, check continuity of splice. Repair as required and
retest before proceeding.
5. Disconnect the sensor from the other controller and plug
the cable into the "SHAKE" terminal of the affected
awning controller.
6. At touch-pad, turn power ON and auto-retract ON.
7. Set auto-retract to the lowest setting.
8. At the unaffected awning, create a firm but gentle
rocking motion with the leading edge of the awning for
about 3-4 seconds.
YES
The affected awning retracts. Original
sensor is defective replace.
Return second shaker to the unaffected
awning controller.
NO
Awning does not retract, control box is
defective – replace
NOTE: The touch pad LEDs will continue to flash after connecting good sensors. It is necessary to power off the
system then turn it back on so that the touch-pad recognizes the sensors are connected
Summary of Contents for Mirage 2-Stage
Page 4: ......
