M
IRAGE
2-S
TAGE
Service
Manual
Carefree of Colorado
16
052588-301r4
In the charts below, YES is a positive response to the test; NO is a negative response.
D04 T
HE AWNING
(
S
)
OPERATE DIFFERENT THAN THE SWITCH MARKINGS
The power switch at the touch pad must be on; the LED will be illuminated if power is present.
A
Does a different awning move when pressing the controls
are pressed (i.e. Awning #2 moves when Awning #1 is
pressed)?
Board marked "Motor 1" corresponds with touch pad
"Awning 1" etc.
YES
Awning #Y moves when Awning #X
buttons are pressed.
- Awning motor wires from Awning #X
and Awning #Y are reversed. Remove
motor wires from control boards,
reattach motor #X wires to motor #X
control board; motor #Y wires to motor
#Y control board.
NO
Go to test B
B
Does the awning operate in reverse of the switch plate
labeling (i.e. extends when retract is pushed)
YES
Motor wires from affected awning are
reversed in control box.
- Open control box and locate motor
wires from affected awning. Reverse
the red and black wires.
NOTE:
For LH motor configurations:
RED WIRE
goes to terminal R
ED
(1);
BLACK WIRE
goes to terminal B
LACK
(1).
For RH motor configurations:
BLACK WIRE
goes to terminal R
ED
(1):
RED WIRE
goes to terminal B
LACK
(1).
NO Reanalyze
condition
D05 T
HE
A
WNINGS
D
O
N
OT
O
PERATE
(A
LL
)
For one awning that does not operate, refer to D03
A
Confirm 110VAC power to control box
5. Shut off power source.
6. Open
control
box.
7. On some early units a fuse is installed on the circuit
board. Check that fuses on circuit boards are intact.
8. Check that 110VAC connections and splices to both
boards are correct and secure. Refer to system
schematic.
9. While observing the circuit boards, have power restored.
The LEDs on the boards should blink red then green.
YES
Power is present; go to test B
NO Check vehicle circuits and fuses.
Repair as required and retest
B
Confirm that touch-pad operating.
1
Press the "Power On" button on the touch-pad. The
"Power On" LED should illuminate.
YES
Power is on, go to step B-4
NO
LED does not illuminate, go to step B-2
2
At bridge, disconnect cable then observe LED while
plugging cable into "BUS" of bridge.
LED should flash red then green.
YES
Power is present, go to step B-4
NO
Go to step B-3
3
Check the cable between the bridge and control box.
As a continuity check, Pin 1 of connector 1 goes to Pin
1 of connector 2; pin 2 goes to pin 2; pin 3 goes to pin 3
and pin 4 goes to pin 4.
YES
Continuity OK; go to step B-4
NO
Replace cable and retest
4
4.1 Disconnect jumper cable between controller boards.
4.2 Disconnect touch-pad from "ACC" of controller #1
and connect to "ACC" of controller #2.
4.3 Does Awning #2 operate when pressing a
command button on the touch pad?
YES
Awning operates, Controller #1 is
defective – Replace control box.
NO
Awning does not respond, touch-
pad/bridge is defective - replace
Summary of Contents for Mirage 2-Stage
Page 4: ......
