9
24
INSTALLATION
Each appliance is provided internally with a 14-way binary dip-switch, the combi-
nation of which must correspond to the combination set on the two dip-switches
located in the access key (see fig.1 page 6).
If the two combinations correspond it will be possible to carry on with the installa-
tion procedure otherwise the control panel buttons will remain inoperable.
To personalise the access combination proceed as follows:
1. Open the container so as to gain access to the upper pcb card;
2. Undo the four screws holding the pcb card in place, remove the card and turn
it over, the dip-switch is located on the underside of the card;
3. Set the desired combination on the dip-switch and then set the corresponding
combination on the two serial access keys supplied with the kit;
4. Replace the pcb card and close the container.
Switch on the power either by connecting the device to the mains or by connecting
the stand-by battery and then verify the correct functioning of the two serial access
keys by inserting them into the slot on the front panel. The led Key-Enabled will
light up indicating that the key has been accepted.
If the led fails to light up but the code combinations on the ACD-148 and the ac-
cess keys are the same contact your dealer.
B1.1
ENTER TRANSMITTER CODE [ 10 characters]:
At this point activate the transmitter which is to be memorised and read the code
number which appears on the display of the device CARDIN ACD 248.
E.g.:
CODE
1F451B207C
Type the code into the terminal only using uppercase letter and then press < CR
>
If the code is wrong (the code also carries redundant information to facilitate the
checksum), the following message appears on the screen:
!! CODE WRONG !! - RETYPE ? [ Y/N ]>>
If the answer Y is given you go back to menu level B1.1 otherwise you go back to
menu level B.
If the introduced code is correct but already present in memory the following mes-
sage appears on the screen:
!! CODE ALREADY STORED !!
TYPE <ESC> to EXIT
at this point you will have to create another random code and then reprogram the
transmitter
If the code is accepted the system asks:
TYPE USER NAME [ max 12 char ]>>
after typing the name and confirming the choice the following message appears
on the screen:
CODE #### ** STORED !! ** >> ENABLE ALL CHANNELS ? [ Y/N ] >>Y
If you have a 2 channel transmitter or if you don’t want to enable all the channels,
answer no, and the following message will appear:
B1.2
- TYPE < CR > to CONFIRM , < SPACE > to TOGGLE
CHA [ Y/N ] Y
Enable each channel separately by alternating between Y and N as required using
the < SPACE BAR > and confirm the choice by pressing < CR >.
The following message will then appear on the screen:
ARE YOU SURE? [Y/N] >>
Answer Y to escape or N to return to menu level B1.2
To check whether the operation was carried out correctly; return to menu level B
and choose option 8 (
enabled users list
). If all is well the code should appear in
the list.
B2.
Add the name of the user
Control panel
Fig.5
SET
COD-GEN
MENU 1
MEMO
MENU 2
POWER
MAIN
BATTERY
CHARGE
KEY-ENABLED
CODE
TRANSFERED
KEY-SLOT
TX-SLOT
MODE
Membrane pannello comandi ACD148
ACD148
29-07-94
DM0058
Description :
Product Code :
Date :
Drawing number :
P.J.Heath
CARDIN ELETTRONICA S.p.A
- 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
Draft :
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
