11
Turn the ignition switch from the OFF position to the
ON position.
ON
ON
Programming the Remote Transmitter
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
Before 15 seconds has passed, push and release the valet
switch 3 times. You will hear a single chirp from the
siren/horn. You are now in transmitter programming
mode.
3X
Press the “Lock” button on the first
transmitter until you hear a
confirmation chirp/beep. The
transmitter is now programmed to
the control module.
Repeat step 3 for each additional
transmitter.
When finished, either turn off the
ignition key or wait for 15 seconds to
get out of transmitter programming
mode. You will hear 1 short + 1 long
chirps/beeps to indicate you are out of
the transmitter programming mode.
OFF
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position the
third time.
OFF
ON
3X
Before 15 seconds has passed, push and release the
valet switch 1 time then push the valet switch a second
time and hold it down until 1 short and 1 long chirp or
beep is heard, then release it. You are now in Alarm
Feature Programming Part 1 programming mode
1X + 1X (Hold)
Programming the Transmitter
Step 1
Step 2
Step 3
Step 1
Step 2
Alarm Feature Programming (Part 1)
Step 4
Step 5
PLUS-4900-IM.qxp 4/30/09 3:06 PM Page 11
