●
2 x M8 Washer
●
2 x M8 Spacer
●
4 x M8 Support Bearing
Fit the two washers to the screws first then the 4 bearings finally finishing with the with the M8 spacers. Once the
screws are assembled fit these screws to your HDZ to the two M8 holes.
Fitted correctly your mounts should look like the below and the screws will not poke through the front of the plate.
Summary of Contents for HDZ 3.3
