CARBATEC.C OM.AU
BS-245H
1.
Set your blade tension first using
the tension knob on the top of the
cabinet, then adjust top and bottom
saw guide bearings, and thrust (rear)
bearings, so that they are not in
contact with the saw blade
(see Adjusting Blade Guide Bearings,
p.24).
Fig. G1
2.
Open the upper and lower cabinet
doors and rotate the upper wheel
clockwise (towards you), watching
the position of the blade on the upper
wheel tyre.
3.
To adjust the wheel position, loosen
the large wing locking nut on the rear
of the upper cabinet, and while hand
turning the upper wheel, rotate the
knurled adjustment knob clockwise
or anticlockwise to change the angle
of the top wheel and in turn the blade
position on the wheel, remembering
to continually turn the upper wheel as
you adjust.
Fig. G2
4.
Tighten the large wing locking knob
when completed.
5.
Check the blade to fence alignment
and adjust as required.
Fig. G1
Fig. G1
Fig. G2
ASSEMBLY
23
