CARBATEC.C OM.AU
BS-245H
C.
INSTALLING TO TRUNNION
1.
Loosen the wing nut between the
upper and lower trunnion, place
into the horizontal position and
re-tighten.
Fig. C1
2.
Slide the cast iron table (smooth
side up) onto the trunion passing the
blade through the table slot from the
rear of the machine.
3.
Align and attach the table to
the upper trunnion with the 4x
M6x12mm hex bolt and lock
washers. Access to the inner rear
holes may be simpler if you leave
them till last, and tilt the table to
the 45°position to give you better
access.
Fig. C2 & C3
4.
Place the blade tension knob onto
the matching shaft on the top of the
upper cabinet.
Fig. C4
FINAL ASSEMBLY
Fig. C1
Fig. C3
Fig. C4
Fig. C2
ASSEMBLY
19
