CARBATEC.C OM.AU
BS-245H
ALIGNMENT & ADJUSTMENTS
ENSURE POWER IS DISCONNECTED
FROM YOUR MACHINE BEFORE
UNDERTAKING ANY ADJUSTMENTS OF
ALIGNMENT.
D.
SETTING BLADE TO TABLE
SQUARENESS
Fig. D
1.
With the blade tensioned adequately
(see Changing Saw Blades p. 24),
adjust the blade trunnion by loosening
the large wing nut, and adjust the
table so that it is exactly 90° to the
blade. Use a good quality engineers
square or other measuring device for
accuracy.
2.
Lock off the trunnion, and with a
Phillips head screwdriver, adjust
the red trunnion dial indicator as
necessary, so it reads ZERO.
E.
SETTING BLADE FENCE
FOR PARALLEL
Fig. E
Setting blade to fence parallel is a process
of trial and error. These adjustments can be
carried out on the table to upper trunnion
mounting points by slightly loosening,
adjusting and re-tightening the table. This
should also be checked after changing blades
or adjusting blade tracking & tension (see
Changing Saw Blades p. 24.)
NOTE: Take your time as the small
adjustments here can make a big difference
in your cuts, but also make the following
adjustments much easier.
Fig. D
Fig. E
ASSEMBLY
21
