CARBATEC.C OM.AU
BDS-1523H
TROUBLESHOOTING
TROUBLESHOOTING
TO PREVENT INJURY TO YOURSELF or damage to the spindle sander, turn the switch
to the “OFF” position and unplug the power cord from the electrical receptacle before
making any adjustments.
PROBLEM
LIKELY CAUSE(S)
SOLUTION(S)
The machine does
not work when
switched on.
1. No power supply.
2. Defective switch.
1. Check all plug connections. Check the
cable for breakage. Check the fuse, or
reset circuit breaker.
2. Return machine to your local dealer
for repair.
Sanding drum does
not come up to
speed.
1. Extension cord too light or
too long.
2. Low current.
1. Replace with adequate size and
length cord.
2. Contact a qualified electrician.
Machine vibrates
excessively
1. Stand or base on
uneven surface.
2. Bearings worn.
1. Adjust stand or base so that it rests
evenly on the floor.
2. Replace bearings.
Sanded edge not
square.
1. Workpiece table not square to
sanding disc or belt.
1. Use a square to adjust workpiece table
to sanding disc or belt.
Sanding marks on
timber.
1. Wrong grit sanding sleeve.
2. Feed pressure too great.
1. Use coarser grit for stock removal and
fine grit for finish sanding.
2. Do not force workpiece against disc
or belt.
27
