CARBATEC.C OM.AU
BDS-1523H
MAINTENANCE
MAINTENANCE
J.
ADJUSTING THE BELT
Use the tracking control knob to adjust
tracking on belt. Use the supplied hex
key to assist with adjustment
if necessary.
Fig. J1A
K.
ADJUSTING THE BELT
ARM ANGLE
The 6” belt arm can be operated
in a vertical or horizontal position.
Adjustment procedures are listed below.
1.
Remove dust port to expose 2 nuts
on axle housing shown.
Fig. K1
2.
Loosen the 2 nuts and adjust belt
arm to desired position.
Fig. K1A
3.
Re-tighten the nuts and replace
dust port.
Fig. J1
Fig. K1
A
A
A
21
