4
HOW TO USE THE SIGHTING NOTCH
To aid in free-hand cutting, sighting notches are located at the front of
the base plate.
VACUUM DUST COLLECTION
There is a vacuum port provided on the blade cover to collect dust
when operating.
Simply attach the vacuum cleaner hose to the vacuum port. Keep the
cap in place when not in use.
WATER FEED SYSTEM
The water feed system allows the machine to cut more effectively.
Ensure that a PRCD interrupter unit is always used.
Mount the Quick Release Water Coupling to the water supply hose.
Adjust the Water Valve for the desired amount of water flow.
WARNING: Great care must always be taken to avoid the risk of
electrocution whenever using water. Never allow water to contact
the electrical parts of the tool.
ALWAYS USE A PRCD INTERRUPTER.
PARALLEL GUIDE
The Parallel Guide allows straight cuts to a desired distance from the
edge.
To mount, insert the Parallel Guide into the slot in the Base Plate and
tighten the Thumb Knobs at the desired position.
STARTING AND STOPPING THE TOOL
WARNING:
Make sure that the power circuit voltage is the same as that shown on
the specification plate of the machine and that switch is “OFF” before
connecting the tool to the power circuit
Switching the machine on and off
Keep the machine steady during switching and during use by holding
the main handle and the secondary handle with both hands.
To switch on:
This machine is equipped with a "LOCK-OFF" switch. To press the
switch, you must first press the release button located at the top of the
switch. Then the trigger switch will be free to be pressed to start the
machine.
To switch off:
Release the trigger switch to stop the machine. After the machine has
been switched off, the blade will still rotate for a time, take care that
parts of your body do not come into contact with the blade while it is
still rotating!
ELECTRONIC OVERLOAD PROTECTION
If while cutting the machine reaches a load approaching overload
level, the electronic overload protection will kick in and shut the saw
off. When this happens, release the trigger and return the machine to
its topmost position (out of the cut) and wait at least 3 seconds before
continuing.
HOW TO USE THE TOOL
Effective control of this powerful saw requires
two-handed
operation
for maximum protection. Note there is a secondary handle as well as a
side handle which has two choices of position. Choose the handle
according to the working conditions. Support the work properly and to
hold the saw firmly
WITH BOTH HANDS
to prevent loss of control
Vacuum port cap
Water tap
Water coupling
Parallel guide
On/off switch
Release button
