Caple C749G, Instruction Manual

Page: 6 / 13

Instruction manual C749G Instruction manual C749G
Please keep this instruction manual for future reference Please keep this instruction manual for future reference
10 11
USING THE BURNERS
The flame symbols printed on the side of the control knobs indicate the
correspondence between the knob and the flame size on the burner.
TO IGNITE A BURNER:
Turn the corresponding knob anti-clockwise up to the maximum position (large
flame, fig.1) and press the knob. If you keep the control knob depressed, the
automatic ignition for the burner will operate.
You should hold down the control knob for 15 seconds after the flame on the
burner has lit. If after 15 seconds the burner has not lit, stop operating the device
and open the compartment door and/or wait at least 1 minute before attempting a
further ignition of the burner.
Burners
1 Rapid burner
2 Semi-rapid burner
3 Auxiliary burner
4 Triple ring burner
INSTRUCTIONS FOR THE USER
PRODUCT OVERVIEW
1 4
2
3
After this 15-second interval, to regulate the flame you should continue turning
the control knob anti-clockwise until the flame is at a suitable level. The operating
position
MUST be at a position between the maximum and minimum position.
To switch the burner off, turn the control knob fully clockwise to the gas off
position. In case of power failure, the burners can be lit by carefully using a match.
USING THE BURNERS
In order to obtain the maximum yield without
waste of gas, it is important that the diameter of
the pan is suitable for the burner potential (see
the following table) to avoid the flame reaching
out past the pan (fig. 2).
Burner Pan Size min. Pan Size max.
Auxiliary 120mm 140mm
Semi-rapid 160mm 180mm
Rapid 200mm 240mm
Triple ring 200mm 240mm
Use the maximum flame to quickly make liquids reach boiling temperature, and
the reduced flame to heat food or maintain boiling. All of the operating positions
must be chosen between the maximum and the minimum ones, never between the
maximum position and ‘off.’
WARNING:
- Do not use cookware that overlaps the edge of the burner.
- When you are no longer using the hob, always check that the knobs are in the
off position.
- If the flame should blow out accidentally, the safety valve will automatically stop the
gas supply after a few seconds. To restore operation, set the knob to the lighting
point and press.
- While cooking with fat or oil, pay the utmost attention as these substances can
catch fire when overheated.
Fig 1 Closed
Minimum
Maximum
Fig 2