Caple C749G, Instruction Manual, Page: 7 / 13

Instruction manual C749G Instruction manual C749G
Please keep this instruction manual for future reference Please keep this instruction manual for future reference
12 13
- Do not place unstable or deformed pans on the burner, so as to prevent them from
overturning or overflowing.
- Make sure that pan handles are placed appropriately to avoid knocking the pans off
from the hob.
- When the burner is started up, check that the flame is regular, and before taking
pans away, always lower the flame or put it out.
CLEANING
Before any cleaning operation, disconnect the appliance from the electric
grid. Don’t use a steam cleaner for cleaning the hob.
It is advisable to clean the appliance when it is cold.
ENAMELLED PARTS
The enamelled parts must be washed with a sponge and soapy water or with a
light detergent.
Do not use abrasive or corrosive products.
Do not leave substances, such as lemon, tomato juice, salt water, vinegar, coffee
or milk on the enamelled surfaces for a long time.
STAINLESS STEEL PARTS
Stainless steel can be stained if it remains in contact with highly calcareous water
or aggressive detergents for an extended period of time. The stainless steel parts
should also be cleaned with soapy water and then dried with a soft cloth.
WARNING:
- After cleaning the burner, make sure that the lid is placed in the housing.
- The 2 reference cuts must be entered on the 2 references made on the
flame retardant.
- The burner cap must be positioned steadily and flat.
BURNERS AND PAN SUPPORTS
These parts can be removed to make cleaning easier.
Remove the burner lids and Flame Spreaders by pulling them upwards and away
from the top plate.
Soak them in hot water and a little detergent or washing up liquid.
After cleaning and washing them, wipe and dry them carefully.
Make sure that the flame holes are clean and completely dry.
Wipe the fixed parts of the Burner Cup with a damp cloth and dry afterwards.
Gently wipe the ignition device and
flame supervision device with a well
wrung-out cloth and wipe dry with a
clean cloth.
Before placing the burners back on the
top plate, make sure that the injector is
not blocked.
Replace parts in the correct order after
cleaning (fig. 3)
The locating pins must fit exactly into
the notches.
GAS TAPS
The possible lubrication of the taps must be carried out by specialised personnel
only.
In case of hardening or malfunctions in the gas taps, contact Caple Service.
Fig 3