Grand Soleil 45’
- -
64
General warning and caution
We remind you that, if all on-board systems work properly, there should be no water in
the bilge. If there is water, first of all check if it is fresh or sea water: in the first case,
inspect the fresh water distribution system; in the second case, inspect the sea water
distribution system, if provided, as well as the other possible sea water leaks (engine,
rudder shaft, seacocks, etc.)
•
We remind you that part of the sea water system is located under the waterline; in case
of leaks or bursting, turn off immediately the relevant seacock.
•
Before starting the fresh water pump, we recommend you to make sure that there is
water in the tanks. If there is no water, the fresh water pump will suck up air and will
work in vain, being consequently damaged. Therefore, if the fresh water pump noise
continues after turning off the taps, we recommend you to turn off the 12 Vdc electrical
panel switch. If the noise is intermittent, check that all taps are well closed and that there
are no leaks in the system.
•
As said above, before starting the water heater both mechanically and electrically, please
read the paragraph “Water heater” at page 31 and the paragraph “220 Vac network” at
page 47.
•
In case of maintenance or repair for a water leak in the distribution system, turn off the
affected supply tap to stop the water flow (see diagram at page 65).
•
The water system allows you to suck up water from one or both tanks by opening the
relevant valves located in the “Tank control panel”.
•
Before winter time empty as possible:
-
the fresh water tanks
-
the entire water system
-
the water heater and the fresh water pump.
•
Before using the sea water system, if provided, make sure that the water is clean where
the boat is moored.
