|
51
DISPLAY STATE TIME
A cycle is comprised of a number of states. Use the following procedure to view the state number and time for
both stations.
1. On the control panel, press
SETUP.
2. Type
18
on the keypad, then press
ENTER
.
“State Time Display” displays on the screen.
3. View the current state number and time remaining for
each station.
4. To exit, press
SETUP
.
PRINT ENTIRE LOG
Print a copy of the disinfection cycle log, then clear the log, at regular intervals. Only the information saved since the
last time the log was cleared is printed.
1. Verify the printer is
ON
.
2. On the control panel, verify the correct station is selected.
If necessary, press
STATION SELECT
to choose the
station (A or B).
3. Press
SETUP
.
4. Type
21
on the keypad, then press
ENTER
. “Print Log?”
displays on the screen.
5. To print the log, press
START
.
6. To exit, press
SETUP
.
Figure 6.8
- Display State Time
Figure 6.9
- Print Entire Log
Summary of Contents for MEDIVATOR DSD EDGE
