CP40
Page 36 of 43
Installation Manual
October 2015 • Rev. 2.7
ELEVATOR CONTROL USING THE SIOPT-16 INPUT/OUTPUT BOARD
NOTE
: For elevator control of up to 16 floors, the SIOPT-16 input/output
board must be installed on top of the CP40 control panel. Special CP40
firmware required for this configuration.
To enable elevator control
:
1.
Connect the communication ribbon cable to the CP40
2.
Connect the power cable to the CP40
3.
Move switch 1 on the
Options DIP Switch (S2)
to the ON position
4.
Press and release the CP40 reset button
