CP40
Page 27 of 43
Installation Manual
October 2015 • Rev. 2.7
Onboard Input/Output Points
The CP40 board is equipped with:
2 onboard supervised inputs
2 onboard output control signals which can be used with external relays
These onboard inputs and outputs can be used if an SIOPT-16 input/output
board is not installed. These points will be mapped as points 1 through 4 in
the Maestro software.
NOTE
: in the Maestro software you must configure points 1 and 2 as inputs,
and points 3 and 4 as outputs. Failure to do so will result in undesired
operation.
For I/O wiring, see pages 25 and 26.
