WX6000 / SX6000
User Commands
- 77 -
Item Code TYPE
Error character strings
Error
Remedy
201F e
INVALID_SIGNAL
Cannot execute command with
current input signal.
Change the input signal.
17 0801 e INVALID_VALUE
Numerical parameters are
invalid or outside the specified
range.
Set the parameters in the correct range.
18
1002 e
NO_LOGO_CAPTURED
Cannot execute command
because the user image is not
registered.
Register the user image.
1003 e
IP_NOT_AVAILABLE
Cannot execute
PROGRESSIVE conversion.
Switch to the correct input signal.
1004 e
POWER_MANAGEMENT_OFF
DPON=ON cannot be set when
PMM=OFF.
Use a setting other than PMM=OFF.
1005 e
DIRECT_POWER_ON
PMM=OFF cannot be set when
DPON=ON.
Use the DPON=OFF setting.
1010 e
INACTIVE_PARAMETER
Parameter is currently in a
disabled state.
Set the parameter when it is enabled.
1011 e
FUNCTION_NOT_AVAILABLE
Objective function is currently in
a disabled state.
Set the function when it is enabled.
2020 e
INVALID_IMAGE_MODE
Cannot set in current image
mode.
Set when other image mode is selected.
203X e
INVALID_RESOLUTION
(***)
Invalid input signal resolution.
Additional information is
indicated in parentheses.
■
OVER_PANEL_RES: input
signal resolution exceeds panel
resolution.
Switch to an input signal with the correct
resolution.
19
-
i INPUT_NOT_FOUND
Input was not switched since
there is no input signal at
AUTOSETEXE=INPUT.
Notification of status only; no particular
measures needed.
* Error codes are 4-digit hexadecimal strings. X represents any character from 0 to 9 or from A to F.
* Items with lower numbers have a higher priority. (Even when multiple errors have occurred, the error with the highest rank is returned.
However, errors of the same item number are ranked with the same priority.)
* Even though the projector is under one of the conditions listed in the Error List, a command that is executable is performed.
For example, an executable command is activated while the zoom lens is driven.
