NOTE:
Error codes caused by echoes at time of sending fax
#005, ##100, ##101, ##102, ##104, ##201, ##280, ##281, ##283, ##284, ##750, ##760, ##765, ##774, ##779, ##784, ##794
Settings using the Dial Registration (user level):
Select "international transmission (1)" when making an entry in the address book. If errors persist, select "international
transmission (2)" and then "international transmission (3)".
Transmission mode selected using One-Touch Dial function or the Speed Dial function will be given priority over the setting
made by the service soft switch.
An international transmission mode may be selected using the keypad if a mode has been selected using this switch; for
settings, see the following table:
Transmission
mode
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
International trans-
mission (1)
*
0
0
1
-
-
*
-
International trans-
mission (2)
*
0
1
0
-
-
*
-
International trans-
mission (3)
*
1
1
0
-
-
*
-
International transmission (1): Selected to ignore the first DIS signal from the other party.
International transmission (2): Selected to transmit a 1850-Hz total signal when transmitting the DIS signal.
International transmission (3): Selected to transmit a 1650-Hz total signal when transmitting the DIS signal.
Detailed Discussions of Bit 7
Select whether to enable/disable sending of a 1080-Hz tonal signal before sending CED signal.
Select "Send" if errors occur frequently because of an echo when reception is from overseas.
NOTE:
Error codes caused by echoes at the time of reception
#005, ##101, ##106, ##107, ##114, ##200, ##201, ##790
■ SSSW-SW04
Functional Construction
Bit
Function
1
0
0
LC monitoring
Monitor
Do not monitor
1
Check the CI signal frequency
Check
Do not checked
2
Final flag sequences of the procedure signal
2 pcs
1 piece
3
Reception mode after sending CFR signal
High speed
High speed/low speed
4
Time to ignore low-speed signals after sending CFR signal
1500 msec
700 msec
5
Check the CS signal frequency (when PBX is set)
Check
Do not check
6
CNG signal at the time of manual sending
Send
Do not send
7
CED signal at the time of manual reception
Send
Do not send
Detailed Discussions of Bit 1
Select whether to check the CI signal frequency.
Detailed Discussions of Bit 2
Select the number of the final flag sequences with the procedure signal (300 bps transmission speed).
Select "2" when the other party's machine does not properly receive the procedure signal sent by this machine.
NOTE:
Error codes occurring at the time of sending fax
##100, ##280, ##281, ##750, ##753, ##754, ##755, ##758, ##759, ##760, ##763, ##764, ##765, ##768, ##769, ##770, ##773,
##775, ##778, ##780, ##783, ##785, ##788
5. Service Mode
23