Canon RE-350, Control Interface Commands Manual, Page: 10 / 63

10
1
2
3
4
5
6
7
With the shutter speed switch, set the
shutter of the
RE-350
.
Set an
ID
number for this
RE-350
using
the
DIP
switches on the rear panel.
Set communication speed for
RS-232C I/F
with the
DIP
switches on the rear panel.
Properly connect the
RE-350
to the
PC
with an approved serial cable.
Turn on the
PC
. (This operation may be
done after the
RE-350
is turned on.)
Turn on the main power of the
RE-350
.
Set the
RE-350
to [O
N
-L
INE
] Mode.
In order to put the
RE-350
in [O
N
-L
INE
]
Mode, the following two methods will be
available:
1. Push the {
RS-232
} button
on the front panel.
2. The PC sends an [O
N
-L
INE
]
or [N
OTIFICATION
] command.
1. The power
LED
on the
RE-350
will be turned on
2. Automatically the
RE-350
will be initialized.
3. The White Balance will be adjusted automatically and the
White Balance
LED
will blink while finding a proper
white balanced setting. If the
RE-350
can not find a
proper setting, the White Balance
LED
will be off, if
setting is found, the
LED
will be on.
4. The
RE-350
will start to find the point of focus, the Auto
Focus
LED
will be blinking. Once the appropriate point
of focus is found, the Auto Focus
LED
will be on, if not,
the
LED
will be off.
1. The
RE-350
will send Request On Line event data to the
PC
, the
RS-232 LED
will blink.
2. After the reception of <Accepted> E-response data, the
RE-350
's status shifts to [O
N
-L
INE
] Mode and the
RS-
232 LED
will turn on. If the
RE-350
receives <Denied>
E-response data, the
RE-350
remains in [O
FF
-L
INE
]
Mode and turns the
RS-232 LED
off.
(Refer to Section 2.5)
The
RE-350
responds with C-response data and its status
shifts to the requested mode and turns the
RS-232 LED
on.
1.3.2 Procedure for Using the RS-232C Serial Interface
Order RE-350's Condition and LED Status Operations