Canon PIXMA MP530, Service Manual, Page: 25 / 91

*1: General notes:
- Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly.
[See 3-2. Special Notes on Repair Servicing, for details.]
- Do not drop the ferrite core, which may cause damage.
- Protect electrical parts from damage due to static electricity.
- Before removing a unit, after removing the power cord, allow the machine to sit for approx. 1 minute (for capacitor
discharging to protect the logic board ass'y from damages).
- Do not touch the timing slit strip film and timing slit disk film. No grease or abrasion is allowed.
- Protect the units from soiled with ink.
- Protect the housing from scratches.
- Exercise caution with the red screws, as follows:
i. The red screws of the paper feed motor may be loosened only at replacement of the paper feed motor unit (DO NOT
loosen them in other cases).
ii. DO NOT loosen the red screws on both sides of the main chassis, securing the carriage shaft positioning (they are
not adjustable in servicing)
QM2-2232
1. Apply grease to the sliding
portions.
[See 3.3. Adjustment / Settings,
(2) Grease application.]
Timing slit strip film
QC1-6394
- Upon contact with the film,
wipe the film with ethanol.
- Confirm no grease is on the
film. (Wipe off any grease
thoroughly with ethanol.)
- Do not bend the film
After replacement:
1. Perform the print head
alignment in the user mode.
- Service test print
Timing slit disk film
QC1-6229
Print head
QY6-0059
After replacement:
1. Perform the print head
alignment in the user mode.
- Service test print
To the table of contents To the top
<Part 1: 3. REPAIR; 3-1. Notes on Service Part Replacement>
1-20