Canon LBP6000 Series, Service Manual

Page: 103 / 146

Chapter 3
3-25
3.1.14.3 Before Removing the Sensor PCB
0025-1234
LBP6000 / LBP6000B
1) Remove the Upper Cover.
(page 3-5)
Reference[Removing the Upper
Cover]
2) Remove the Left Cover.
(page 3-3)
Reference[Removing the Left Cov-
er]
3) Remove the Right Cover.
(page 3-2)
Reference[Removing the Right
Cover]
4) Remove the Rear Cover.
(page 3-1)
Reference[Removing the Rear Cov-
er]
5) Remove the Main Controller PCB.
(page 3-17)
Reference[Removing the
Main Controller PCB]
3.1.14.4 Removing the Sensor PCB
0025-1235
LBP6000 / LBP6000B
1) Remove the terminal [1], and free the harness [3] from the Harness Guide
[2].
F-3-82
2) Disconnect the 4 connectors [1], and free the harness [3] from the Harness
Guide [2].
3) Disconnect the connector [4], and remove the Sensor PCB [5].
F-3-83
3.2 LASER EXPOSURE SYSTEM
3.2.1 Laser Scanner Unit
3.2.1.1 Preparation for Removing the Laser Scanner Unit
0019-2196
LBP3100 / LBP3010B
1) Removing the Upper Cover
(page 3-3)
Reference[Removing the Upper
Cover]
2) Removing the Left Cover
(page 3-2)
Reference[Removing the Left Cov-
er]
3) Removing the Right Cover
(page 3-2)
Reference[Removing the Right
Cover]
4) Removing the Front Cover
(page 3-6)
Reference[Removing the Front
Cover]
Points to note at installation
When attaching the terminal [1], make sure that the contact spring [2]
contacts as shown.
[2]
[1]
[1]
[2] [3]
Points to Note at Installation
When installing the terminal [1], be sure that the Contact Spring [2] is in
contact with it as shown below.
[1]
[1]
[2] [5] [4] [3]
[2]
[1]