Canon LBP1760P, Service Manual

Page: 157 / 394

7. Removal of the duplexing unit sole-
noid
1) Remove the left cover.
2) Follow the steps 1) and 2) in the duplex-
ing unit driver PCB removal procedures
to remove the upper feed guide and the
lower feed guide.
3) Disconnect the connector, then disen-
gage the cable from the cable guide.
4) Remove the E-ring and then the lever.
➀
Connector
➁
Cable
➂
Cable guide
➃
E-ring
➄
Lever
Figure 3-10-13
5) Remove the 2 screws, then take out the
duplexing unit solenoid.
➀
Screws
➁
Duplexing unit solenoid
Figure 3-10-14
8. Removal of the duplex feed motor
1) Remove the right cover, left cover and
top cover.
2) Follow the steps 1) and 2) in the duplex-
ing unit driver PCB removal procedures
to remove the upper feed guide and the
lower feed guide.
3) Open the rear cover, remove the screw,
then the connector cover.
➀
Screw
➁
Connector cover
Figure 3-10-15
4) Open the rear cover, and then discon-
nect the 3 connectors.
➀
Connectors
Figure 3-10-16
3 - 43
CHAPTER 3
➄
➂
➀
➃
➁
➀ ➁
➀
➁
➀