Canon iR2030, Service Manual

Page: 389 / 418

Chapter 16
16-5
6) A list of system software programs contained in the system CD is displayed. Uncheck the checkboxes of unnecessary folders and system software programs, and
then click the "REGISTER" button.
This machine allows two or more system software programs to be register at the same time. However, it does not allow two or more them to be downloaded at the
same time. If two or more software programs need to be upgraded, download them one by one.
F-16-5
7) When the system software program registration result appears, click the OK button.
F-16-6
16.2.2 Registering the System Software (Touch panel type)
0017-6011
iR2022i / iR2025 / iR2030 / iR2018i
System software programs to be downloaded need to be registered in the SST.
The system software programs are registered with the names listed below.
<Software Programs Preinstalled in Main Unit>
Machine name: iR2018i/iR2022i/iR2022K/iR2025/iR2025i/iR2030/iR2030i
Unit name:
- Main controller: System
- Boot program: Boot
- 16MB ROM PCB: PCL_op (for the standard model)
- 32MB ROM PCB: PCL_Common (for the model equipped with the PCL printer kit-W1)
- CA certificate (distributed only as necessary)
[Preparation]
Have the following ready:
- PC in which SSTv3.21 or later is installed (Download a CA certificate of version of SSTv3.31 or higher)
- System CD
[System Software Registration Procedure]
1) Start the PC.
2) Insert the system CD in the PC.