Canon iR2030, Service Manual

Page: 311 / 418

Chapter 14
14-7
14.4 Finisher Error Codes
14.4.1 Error Code Details
0017-6043
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
T-14-8
Display
code
Detail
Code
Main Cause/Symptom Countermeasure
E500 0001 Finisher communication error
Data communication could not be performed
normally. It has been retried three times in vain. - Check the connectors of the finisher controller PCB and DC controller PCB for
normal connection.
- Replace the finisher controller PCB.
- Replace the DC controller PCB.
E520 0001 - Offset motor or finisher controller PCB failure
- Offset HP sensor failure
- The offset motor was driven for 1000 ms in the
HP sensor approach direction, but the offset HP
sensor did not turn on. - Check the connector of the offset HP sensor.
- Check the connector of the offset motor.
- Replace the offset HP sensor.
- Replace the offset motor.
- Replace the finisher controller PCB.
0002 - Offset motor or finisher controller PCB failure
- Offset HP sensor failure
- The offset motor was driven for 1000 ms in the
HP sensor escape direction, but the offset HP
sensor did not turn off. - Check the connector of the offset HP sensor.
- Check the connector of the offset motor.
- Replace the offset HP sensor.
- Replace the offset motor.
- Replace the finisher controller PCB.
E531 0001 - Staple unit failure
- Staple HP sensor failure
- Finisher controller PCB failure
- The staple home position was not left when 400
ms have lapsed since start of staple operation. - Check the connector of the staple unit.
- Replace the staple unit.
- Replace the finisher controller PCB.
0002 - Staple unit failure
- Staple HP sensor failure
- Finisher controller PCB failure
- The staple home position had been left once, but
it was not reached again when 400 ms have lapsed
since start of staple operation. In addition, the
staple home position could not be reached by
performing reverse operation for 400 ms. - Check the connector of the staple unit.
- Replace the staple unit.
- Replace the finisher controller PCB.