Canon iR2030, Service Manual

Page: 358 / 418

Chapter 15
15-36
BIT 05: BW-SEND -> SEND
BIT 06: CL-SEND -> SEND
BIT 09: BDL-IMAGE( 600) -> CARPS2
15.11.3 Inactivity of the transmitted license
0017-8539
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
Inactivity of the transmitted license
Situation of using this service mode
This service mode is to be used exceptionally on the assumption that when malfunction occurs on the device (caused by device) and the license to be transferred to
the substitute device and to inactivate the license.
This operation is called ' Inactivity of the transmitted license'. Transmission could be selected to the same device and could be used to cease the function temporary.
But if the license is made inactive by mistake, it is necessary to call the dealer to reactivate.
Take utmost precaution when inactivating the license
To inactive the license, operation through the service mode has to be made and to prove the function is inactive; issue of the function inactive certificate key is
necessary.
This operation is valid to any of the each optional function and at the point of issuing the function inactive certificate key the function will be inactive and could
not be used.
New license key to install to the transmitted device will be issued when the information of function inactive certificate key, serial number of the transmission origin
device, serial number of new destination of transmitting device and the reason for transmitting is given to the dealer. Take a note of the new license key and after
the registration to the new transmitted device, inform the user that the new license key should be kept with care.
Operation procedures
(1) Go into the service mode and indicate the below mentioned service mode. (Key operation to go into the service mode is to be pressed one at a time. Orders are
*, 2, 8, *).
After going into the service mode, use the arrow on the both sides of the touch panel and press 'OK' if the decision is made.
(2) Indicate '#LMS'.
(3) Press 'OK' and indicate '#LMS INACTIVE'.
(4) Indicate 'BDL-IMAGE (CARPS 2 for Japanese market) or 'SEND'.
(5) Press 'OK'.
(6) Press '2' from the numeric keypad and press 'OK'.
F-15-7
1.Take a note of the license transmit number which will be indicated with 24 digits.
2.The indicated number is just for this operation and it would not be saved.
3.If the power is switched off, the indicated number will disappear and if the note of the number has not been taken, transmission of the license will be impossible.
4.Even pressing the reset key to clear the indication, there will be no recovery of the number.
Example of the transmitted license indication:
F-15-8
(7) Switch the power supply OFF/ON of the main machine.
Reference:
At procedure (4) when indicating the license option, it indicates ' 001 1'. The last digit '1' shows that the license is active.
After transmitting the license the last digit will change to '2', which means that the license has been transmitted.
If the option is standard equipped, the last digit will indicate '3', which means that the license could not be transmitted.
(8) Contact the dealer and inform the function inactive certificate key, serial number of the transmission origin device, and serial number of new transmiting device,
which is necessary to transmit the license.
Upon given information above, new license key will be issued, which the license could be registered to the new transmitting device.
(9) Register the new license key to the transmitted device and confirm that the function is active.
15.12 eRDS Parameter Settings (E-RDS)
15.12.1 Settings Related to e-RDS
0017-6179
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
OK
#SEND
001 1
Press '2' from the numeric
keypad and press 'OK'.