Canon imageRUNNER C1335 Series, Service Manual

Page: 527 / 607

8
8
8-88
8-88
Service Mode > COPIER > OPTION > FNC-SW
Service Mode > COPIER > OPTION > FNC-SW
COPIER> OPTION> FNC-SW
ECO-TMP Setting of eco mode shift temperature
Details To set the offset value of temperature to shift to eco mode.
When the Environment Sensor detects that the temperature drops to the
specified temperature, the machine enters eco mode and the fan stops.
Decrease the value when any problem (sticking of delivered papers
together, toner adhesion, etc.) occurs in eco mode. (The machine is
more likely to be recovered from eco mode.)
To reduce the drive noise from the fan, increase the value. (The machine
is more likely to enter eco mode.)
Use case • When changing the temperature to shift to eco mode
• When any problem (sticking of delivered papers together, toner
adhesion, etc.) occurs in eco mode
• Upon user’s request (to reduce fan drive noise)
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and press
Start key.
Display/adj/set range -10 to 10
Unit 1 deg C
Default value 0
STP-TMP Temp rise prev mod stop seq temp thrshld
Details To set the threshold value of the temperature of the Developing
Assembly to execute temperature rising prevention mode stop
sequence.
Decrease the value when any problem (toner adhesion, etc.) occurs.
Use case • When changing the temperature to execute temperature rising
prevention mode stop sequence
• When any problem (toner adhesion, etc.) occurs
Adj/set/operate method Enter the setting value, and then press Start key.
Display/adj/set range
0 to 50
Default value 48
COPIER> OPTION> FNC-SW
WT-FL-LM No. of fed sht after wst tonr full dtct
Details Since the Waste Toner Full Sensor detects toner full optically, timing
to display the waste toner near full notice may vary depending on the
concentration of toner.
Usually, when approx. 1000 sheets (calculated with full color, 5% image
ratio) are fed after the near full notice, it is judged as full level, but in
some cases, it is not actually reached to the full level.
According to the usage status of the machine, set the number of sheets
to be fed after the near full notice until toner full (the machine stops).
As the value is changed by 1, the number of sheets is changed by 250
sheets (calculated with full color, 5% image ratio)
Use case • When the user points out that full waste toner is detected earlier than
the actual timing
• When replacement of the Waste Toner Container cannot be done in
time at normal timing because of large volume output
Adj/set/operate method Enter the setting value, and then press Start key.
Caution
• When image ratio is high, toner full may be detected before reaching
the specified number of sheets.
• Toner leak may occur when changing the value drastically.
Display/adj/set range 0 to 8
0: 0 sheet (toner full immediately after near full)
1: 250 sheets
2: 500 sheets
3: 750 sheets
4: 1000 sheets, ... 8: 2000 sheets
Unit 250 time
Default value 4
Related service mode COPIER> OPTION> DSPLY-SW> WT-WARN